logo

French Drains

How To Construct A French Drain - Part 2

Part 1

While some French drains are constructed using a solid PVC pipe, I do not recommend it. Not only does weeping tile direct the flow of the water, by having holes around its circumference it will allow water to exit where the ground is dry, hence, providing a natural method of watering.

teds free plans banner

Solid drainage pipe should only be used as a discharge line and when the drainage line passes areas where tree and shrub roots are present. If you use drainage pipe with holes around its circumference, it will attract tree and shrub roots, that may eventually damage the drainage pipe and prevent water from flowing. The use of a solid pipe in these areas will prevent tree and shrub roots from damaging the French drain system.

In both cases the slope should be a minimum of 1 in 200 (1 foot drop for every 200 feet of lineal distance), although I would recommend a slope of 1 in 100 if at all possible in order to provide adequate water flow. This shouldn't indicate that a French drain must be long, when in fact they can be relatively short, a few feet. French drains should be used behind retaining walls to reduce water pressure that may eventually shift or even topple the wall.

Additional information on retaining wall drainage

Ground drain

Figure 6 - Ground drain

Laser level

Figure 7 - Laser level

There are a couple of primary considerations:

  1. The installation of a ground drain, as shown in Figure 6, at the highest end of the French Drain if there is a specific area in the landscaping that collects water.
  2. Determining where the water flowing in the French drain will exit. It cannot exit to a neighboring property. Exiting to roadways is usually acceptable, although the homeowner should check with their local building department to ensure compliance to any bylaws.

If there is no adequate area for drainage it may be necessary to create a drainage bed similar to that employed for septic tanks.

It is important to put some thought into planning the route of your French drain once the starting and ending points have been determined. It is not necessary that the French drain make a direct run from the starting point to the ending point. The French drain can be laid in any configuration as long as it follows a downward angle of at least 1:200.

The use of a laser level, as shown in Figure 7, is a good method of determining the current topography of the property, as shown in Figure 8. Table 1 provides the definitions for Figure 8.

Determining property slope using a laser level

Figure 8 - Determining property slope using a laser level

Definitions For Figure 8

A - Low area on property

B - Graduated stick

C - Laser level

D - Height of laser level from ground

 

It is also possible to connect multiple collector French drains to one main French drain to carry all of the water away, as shown in Figure 9.

Multiple collector French drains connecting to one main French drain

Figure 9 - Multiple collector French drains connecting to one main French drain

It is wise to call your local utilities and have them mark your property for locations of their underground pipes, electrical and communication cables. The service is usually free.

Make a sketch of the property, and drop in the route or routes of the proposed French drains. Make sure that they clear any current landscaping, such as trees and all utilities. Remember that a downward slope must be maintained at all times.

Mark the route on the property using wood stakes and string.

Figure 10 - Landscape fabric

The trench for the French drain can be dug by hand or you can use a small backhoe or a wide trenching machine.

Figure 11 shows the complete installation of the French drain.

Completed installation of a French drain.

Figure 11 - Completed installation of a French drain.

garden ebook

Click Here!

Share |